Get ready for work—you must wear:

• a work shirt and pants,
• work shoes with composite toe caps,
• work gloves. 

Before you start work, remember that you must:

• Complete health and safety training and on-the-job training,
• Have no health contraindications to performing the work.
• Be familiar with the operating instructions for the machines and equipment used at your workplace.

Before starting work:

• Visually check the technical condition of the workplace: conveyor belt components, manual pallet truck, work table and its equipment, and electrical insulation mats.
• Visually check the condition of the insulation of wires and cables, plugs, switches, and sockets. 
• Report any faults, damage, or deficiencies to your supervisor.
• Check where the nearest emergency stop buttons for the conveyor belt are located. 

During work:

• Bring the pallet with goods (cardboard box/pallet box) using a manual pallet truck, following the manual transport standards.

• Place the pallet next to the workstation, keeping escape routes and access to fire-fighting equipment clear.
• Stand with both feet on an insulating mat when using electrical equipment (scanner, computer).
• Maintain an upright posture, avoid prolonged slouching, and position tools and materials so that you do not have to twist your torso.
• Remove goods one at a time, holding them with both hands and exercising caution.
• Scan the item and enter the goods into the computer program.
• Place the goods in the correct place (in the green pallet box on the conveyor belt or return them to the pallet).
• If the goods are damaged, return them to the place from which the pallet with the goods was taken.
• Keep containers away from electrical cables at all times.
• Keep the floor clean and dry (do not allow wet, uneven, slippery, or contaminated surfaces).
• Focus only on the tasks you are performing, and ensure your own safety and that of your surroundings. 
• Withdraw faulty conveyor belt parts from use, clearly mark them with information signs, and secure them to prevent the machine from starting.

After finishing work:

• Turn off the computer.
• Put your work tools back in their designated place.
• Tidy up your workstation.

What is NOT ALLOWED?

• Repair or upgrade equipment and workstations.
• Do not touch damaged cable insulation or electrical installations.
• Restart machines or equipment before the damage has been repaired.
• Remove covers and safety devices from equipment. 
• Allow unauthorized persons to work.
• Walk over or under conveyor belts.

Failure or accident?

• If something breaks down, report the fault to your supervisor immediately.
• If an accident has occurred, do not touch anything and inform your supervisor.
• Make sure that there are NO containers on the scale during an emergency stop.
• In an emergency, turn off the conveyor belt using the STOP buttons.
• In the event of an accident, provide first aid to the injured person and call the emergency services if necessary.