Get ready for work, you must wear:

• a work shirt and pants,
• work shoes with composite toe caps,
• work gloves.

Before you start work, remember that you must: 

• Complete health and safety training and on-the-job training.
• Have no health contraindications to performing the work.
• Be familiar with the operating instructions for the machines and equipment used at your workplace.

Before starting work

• Check the condition of the forklift, pallets, and containers before use.
• Make sure that the workplace is clean and tidy.
• Report any faults to your supervisor.

During work:

• Use only undamaged pallets.
• Stack containers securely – heavier ones at the bottom, lighter ones at the top.
• Remember that containers must not protrude beyond the outline of the pallet.
• The load must not exceed 2 meters in height.
• Secure irregular goods with fillers.
• After stacking the containers, secure them properly:

1. Securing the load with stretch film

• • Wrap the load around its entire height, starting from the pallet.
  • Use the inner side of the film (it sticks better). 
  • Wrap the load several times, at least 3 times at the top.
  • The film should be taut, but not stretched too tightly.
  • Additionally, weave the film through the corners of the pallet at the top of the load.

2. Securing the load with transport straps

• • Pass the strap through the pallet and over the load – without twisting.
  • Insert the end of the strap into the tensioner, remove any slack, and tighten manually.
  • Close the tensioner and hide the loose strap.
  • Do not use straps to lift the load.
  • Only use undamaged straps with a legible label.
  • Do not place the tensioner on the edge of the load.

3. Securing the load with plastic straps (banding)

• • Pull the straps over the top of the load (from 2 or 4 sides).
  • Then pass them under the upper pallet frame and tighten.
  • If the straps do not cover the entire load, secure it additionally with stretch film.

After finishing work

• Return the equipment to its designated place.
• Clean up the work area.
• Check that the area does not pose a hazard.

What should NOT be done?

• Place containers at a height of more than 2 m.
• Fail to secure the load.
• Use damaged pallets.
• Throw or stand on containers.
• Move around ramps and floor edges.

Breakdown or accident? 

• If something breaks, report the fault to your supervisor.
• If an accident has occurred, do not move anything and inform your supervisor.
• In the event of an accident, provide first aid to the injured person and call emergency services if necessary.