Before you start work, you must:
- Complete health and safety training and on-the-job training.
- Have no health contraindications to performing the work.
- Be familiar with the operating instructions for the machines and equipment used at your workplace.
Before starting work:
- Visually check the technical condition of the gate.
- Assess the condition of the gate's power cables; if you find any damage, report it to your supervisor.
- Before opening or closing, check that no one is in the gate's movement area.
During operation:
- Drive the forklift (at a speed of 3 km/h) up to the battery room gate, get out of it, and open the gate using the button on the control panel.
- Make sure that the gate is fully open before driving under it. The gate will close automatically after 20 seconds.
- Be careful when lifting the gate and driving through it.
- If the gate does not operate automatically, use the control panel to lower or raise it.

After finishing work:
- Tidy up the work area.
- Drive the trolley (at a speed of 3 km/h) in front of the battery room gate; the sensor will detect the movement of the trolley and the gate will open automatically.
- Make sure that the gate has opened completely and drive out of the battery room; the gate will close automatically after 20 seconds.
What NOT to do?
- Repair or maintain equipment by unauthorized persons.
- Repair or maintain equipment that is in motion and under voltage.
- Restart the machine or device without repairing the damage.
- Drive or walk under a gate that is in motion.
- Pass through the gate when there is a door intended for this purpose nearby.
- Manipulate the safety curtain or block it.
Failure or accident?
- If something breaks down, switch off the device and secure it against restarting (red emergency button on the gate control panel) and report the fault to your supervisor.
- If an accident has occurred, do not touch anything and inform your supervisor.